Covers the painted center section of the R2’s front bumper, where road debris meets the front of the vehicle. This mini kit focuses on the area between the oval headlights; bumper sides and lower trim are outside its coverage.

The precut pattern follows the front center panel’s contours. There is no pattern to measure and no trimming on the vehicle—just careful alignment before you squeegee the film into place.

Optically clear, gloss TPU film preserves the look of your paint beneath a discreet protective layer. The hydrophobic surface helps water bead, and heat helps reduce fine surface marks in the self-healing coating.

Choose 8 mil or thicker 10 mil film. Both options provide the same center-panel coverage and clear gloss finish, so the choice of thickness does not change the look you are going for.

The single-piece layout keeps the job more approachable than a full bumper wrap. Follow the installation video through surface preparation, wet alignment, squeegeeing and finishing the edges. Take your time around the curves.

Your selected film comes with two 2 oz spray bottles for slip and tack solutions, plus a 2 × 2 inch rubber squeegee. Add water to both bottles before you begin, and allow two days for the film to cure after installation.