Front Bumper PPF | Rivian R2, Clear Paint Protection Film
Precut clear paint protection film for the Rivian R2βs front bumper, in three coverage options: Middle Only covers the painted center panel between the oval headlights, Sides Only covers the painted bumper sections outboard of each headlight, and Full (3pc) includes all three pieces. It helps protect against rock chips and scratches while keeping the original paint visible. Choose clear gloss 8 mil or 10 mil film, with a manageable wet installation and the essentials included.
Pairs well with
Product Features
π‘οΈ Protection where it counts
Middle Only covers the painted center section between the oval headlights, where road debris meets the front of the vehicle. Sides Only covers the painted bumper sections outboard of each headlight. Full (3pc) combines all three pieces. The lower trim is outside the coverage of every option.
𧩠Precut pieces. Shaped for R2.
Each precut piece follows the contours of its bumper panel: one center piece, plus a driver-side and a passenger-side piece in the Sides Only and Full (3pc) options. There is no pattern to measure and no trimming on the vehicleβjust careful alignment before you squeegee the film into place.
π Clear film. Original finish.
Optically clear, gloss TPU film preserves the look of your paint beneath a discreet protective layer. The hydrophobic surface helps water bead, and heat helps reduce fine surface marks in the self-healing coating.
π Your choice of thickness
Choose 8 mil or thicker 10 mil film. Both thicknesses provide the same coverage for the size you choose and the same clear gloss finish, so the choice of thickness does not change the look you are going for.
π οΈ A manageable DIY install
Middle Only is a single piece; Sides Only and Full (3pc) add two side pieces that take extra time around the headlights. Follow the installation video through surface preparation, wet alignment, squeegeeing and finishing the edges. Take your time around the curves.
π¦ The essentials, included
Your selected film comes with two 2 oz spray bottles for slip and tack solutions, plus a 2 Γ 2 inch rubber squeegee. Add water to both bottles before you begin, and allow two days for the film to cure after installation.
More Info / Specifications
Front Bumper PPF | Rivian R2, Clear Paint Protection Film
Included in the Kit
Materials
Install Time & Difficulty
Fits Models
How to install
FAQs
How long does PPF last?
Paint protection film, if installed properly on a clean surface will last anywhere between 5 to 10 years.
Can I install PPF over ceramic coating or wax?
No, you shouldn't. These chemical treatments will prevent the paint protection film from properly adhering to the paint. If your vehicle is ceramic coated or waxed, do not attempt PPF installation.
Can I use car wash if I have PPF?
Yes, please allow 2-3 days after PPF installation before using a car wash though. This allows the paint protection film to fully cure. Also, please consider using touchless car washes, to avoid the risk of edges picking up by scrubbing the car with a towel.
Can I install PPF in the winter?
Yes! You may need a heat gun or a hair dryer though, as paint protection film gets stiff and unsticky in cold weather. If the surface you are installing on is curvy, use a heat gun or a hair dryer to warm up the film - this will make it soft and sticky. When doing that, remember to spray the PPF on top with soapy solution, to avoid the squeegee dragging against it. Also, if any edges are lifting up at all, heat them up and push them with your fingers to properly seal them.