Fill the spray bottle with water
Fill up the provided spray bottle with water. It already includes a drop of soap in it. To open the flat spray bottle, just pull the middle tab up (the one that has a spray hole). If you find it hard to pull up, use pliers.
Spray the surface where you will be installing the HOV sticker and clean it.
Once cleaned, spray the surface again. Then spray your fingers, spray the PPF/tint on top, then peel off the PPF/tint and spray its adhesive side.
Apply & align
Apply the wet PPF/tint on the surface.
Squeegee out the water
Use the provided squeegee to remove the water from under the PPF. Make sure you use the soft side of the squeegee to prevent scratching the PPF. Keep using the squeegee until there are no bubbles. You may need to re-position the PPF/tint as you remove the water, as it's possible it will slide a bit during this process.
If you purchased the tinted option, please follow the same steps to install the tint layer on top of the HOV sticker, after installing the clear PPF first and the HOV sticker on top of it.
Let it cure
Wet installations require minimum of 24 hours to cure. Please avoid car washes for 1-2 days after applying the PPF/tint.